Sibelmed Somnibel Pro Manuel D'utilisateur page 35

somnibel Pro
User's Manual
reducing the product's safety. Hold always the connectors when disconnecting the device.
Deteriorated accessories (battery charger or USB cable with broken cases, cables or connectors) should not be
used since there is risk of cramps. Contact SIBEL S.A.U. or your provider for acquiring new ones.
In case of device overheating during battery charge or during use, immediately disconnect it from the mains
and stop using the device. Contact SIBEL's After Sales Service or your dealer.
Deteriorated fastening adhesives (excessively wrinkled or partially removed from the protecting cover) should
not be used since their adhesiveness may be reduced. Dispose defective adhesives and use a new one.
Fastening adhesives are intended for single-use. Do not reuse the adhesives since there is risk of cross-infection
between patients and their adhesiveness is considerably reduced after the first use. Use always a new adhesive
for each treatment session.
The cleaning instructions in this manual must be carefully followed.
No parts are allowed for temporary immersion. IT MAY CAUSE ELECTRIC DISCHARGE.
Somnibel Pro
The system is prepared to work at room temperature. Avoid exposing any part of the system to
heat sources. Also avoid direct exposure to sunlight. Temperature changes cause condensation and moisture.
Before using the system, allow the device to acclimate to ambient temperature.
The system is not designed to work in an explosive environment or in the presence of flammable anesthetics
or gases of any kind. MAY CAUSE EXPLOSION.
The detection of body position and the generation of vibrating stimulus are considered essential operation (so
that the specified accuracy can be met and / or the technician is able to perform a correct follow-up), as well as
EN 8
534-80P-MUM_Rev.1.08