Image Mirror On/Off; Special Functions; Dome Initialisation; Firmware Upload - Videotec MDI Manuel D'instructions

10.5 Image mirror ON/OFF

The camera has in-built image mirror which can, if necessary, be turned OFF or ON. Factory default is OFF.
Call Preset 85 to turn Mirror ON
Call Preset 86 to turn Mirror OFF

11 Special functions

11.1 Dome initialisation

The dome can be reinitialized by calling Preset 34. The dome performs a power-up routine and restores the
default setting for all camera performance adjustments (previously stored presets are not lost).

11.2 Firmware upload

Preset 99 is used to prepare the dome for the upload of new firmware. It is called automatically by the firmware
upload tool.
Calling Preset 99 without subsequenlty upload new firmware will cause the dome to stop functioning. It
is necessary to cycle power to the dome to reactivate it if Preset 99 is acidentally called.

11.3 Factory presets

Four presets are programmed during manufacturing to test the targeting accuracy of the dome. Table 12
describes the camera positions for these presets. While certain controllers can call these presets, they cannot
overwrite the factory programmed positions.
Preset number
50
51
52
53
Table 12 – Factory sored preset positions stored
The presets, really usable to control the dome, are those from 1 to 32.
Pan position
0°
0°
-90° (right limit)
+90° (left limit)
Pag. 14
Tilt position
0°
-90°
0°
0°
MNVCMDI_0419