2
inTenDeD use
use of the 1062 electrical position feedback that does not
comply with the instructions could present risks to people,
nearby installations and the environment.
▶ The 1062 electrical position feedback, fitted to an on/off valve,
is used to detect the status - open or closed - of this valve.
▶ The position feedback can be fitted to an actuator valve with a
diameter of 40 to 125 mm.
▶ Protect this device against electromagnetic interference, ultra-
violet rays.
▶ Protect a device installed outdoors from the effects of climatic
conditions.
▶ Use this device in compliance with the characteristics and
commissioning and use conditions specified in the contractual
documents and in the user manual.
▶ Requirements for safe and proper operation are proper trans-
port, storage and installation, as well as careful operation and
maintenance.
▶ Only use the device as intended.
2.1
Restraints
Observe any existing restraints when the device is exported.
6
english
Type 1062
Intendeduse
2.2
ex certification
Ex certification is only valid if modules and components approved by
Bürkert are used as indicated in this user manual.
The electronic modules can only be combined with the types of
pneumatic valves authorised by Bürkert; if this is not the case, Ex
certification is void.
Any modification to the system or to one of the modules or compo-
nents not authorised beforehand also voids Ex certification.