Type 2060 INOX
2.1
Symbols
Warns of fatal or serious injuries:
DANGER!
Warns of an immediate danger!
WARNING!
Warns of a potentially hazardous situation!
Warns of moderate or minor injuries:
CAUTION!
Warns of a potential danger!
NOTE!
Warns of damage!
Important tips and recommendations.
→ Designates a procedure which you must carry out.
3
INTENDED USE
The Type 2060 INOX angle seat valve is designed to control the
flow of liquid and gaseous media.
• To use the device, observe the permitted application conditions.
• Only use the device when it is in perfect condition; always ensure
proper storage, transportation, installation and operation.
• In potentially explosive environments, the device must only be
used in accordance with the specifications on the separate
Quickstart
Ex-type label. The additional information and safety instructions
relating to Ex areas enclosed with the device must be adhered
to when deploying the device.
• Devices without a separate Ex type label must not be used in the
potentially explosive atmosphere.
• Use the device only in conjunction with third-party devices and
components recommended or approved by Bürkert.
• Only use the device as intended.
4
BASIC SAFETY INSTRUCTIONS
Danger from high pressure.
▶ Before loosening lines or valves, switch off the pressure and
bleed/drain the lines.
Danger due to electrical voltage.
▶ Before reaching into the device or the system, switch off the
power supply and secure to prevent reactivation!
▶ Observe the applicable accident prevention and safety regu-
lations for electrical devices!
Risk of crushing due to moving pneumatic port.
▶ Do not touch the moving pneumatic port when opening and
closing the device.
▶ Do not reach into the area directly above and below the pilot
air port.
Risk of pressure surge flow with flow direction above the seat.
▶ Because of the risk of pressure surge, angle seat valves with the
flow direction above the seat must not be used for fluid media.
English
3