Corghi CompactLine EM 9280 Manuel D'utilisation page 99

ALU 2 balancing programme:
calculates statistically the balancing weights to be applied on the inner side and the
inner part of the rim, as illustrated by the icon.
ALU 3 balancing programme:
calculates statistically the balancing weights to be applied on the inner part (inner and
outer side) of the rim, as illustrated by the icon.
ALU 4 balancing programme:
calculates statistically the balancing weights to be applied on the inner side and the
inner part, outer side of the rim, as illustrated by the icon.
ALU 5 balancing programme:
calculates statistically the balancing weights to be applied on the inner part and the outer
side of the rim, as illustrated by the icon.
Correctly set the wheel's geometric data as described for the Dynamic balancing programme.
- Perform a spin.
- At the end of the spin, select the Balancing programme icon
button until the required programme is selected.
- After performing a spin, when in the centred position, the video displays instructions for
where to position the balancing weights relating to the selected programme: always to 12
o'clock if the weight is a conventional spring type or adhesive but outside the rim, whereas
for application of the adhesive weight inside the rim, use 6 o'clock as a reference if the
"LASER" configuration is active and 12 o'clock if the "H12" or CLIP configuration is active.
- Set the wheel's rated geometric data by following the steps described in the WHEEL DATA
ENTRY chapter. If the values of the diameter and of the distance between the balancing
planes, recalculated on a statistical basis starting from the rated geometric data of the
wheel, exceed the normally accepted interval stated in the TECHNICAL DATA section, the
A5 message is displayed.
IMPORTANT: in the ALU1 and ALU2 programmes, the imbalance displayed by the machine
for the outer side is with reference to the centre of gravity of the adhesive weight aligned
with the shaft assembly bearing flange, see Figure 20a.
Operator's manual EM 9280 - EM 9280 C CompactLine
and press the ENTER
99
UK