Corghi CompactLine EM 9280 Manuel D'utilisation page 96

3 Apply the adhesive weight manually using the centre of the weight-holder cavity as a
reference for the weight centre line.
"Movable planes" programme
(available only with ALU P programmes and SELECTION POSITION
APPLICATION ADHESIVE WEIGHTS configuration CLIP)
This function is automatically enabled when an ALU P programme is selected.
It modifies the former selected positions for the application of adhesive balancing weights,
in order to allow perfect wheel balancing using commercially available adhesive weights
in multiples of five grams. The accuracy of the machine is thereby improved, avoiding
rounding-off or cutting the weights to be applied to come closer to the actual unbalance
values.
The modified positions, where the adhesive weights are to be applied, are identified
by the user according to the information given by the wheel balancer (see the Balancing
weight application section).
"HIDDEN WEIGHTS" PROGRAMME
(available on with ALU P programme)
This programme divides the outer weight Pe into two weights, P1 and P2, located in any
position chosen by the operator.
The only condition is that the two weights and the original outer weight Pe must be within
an angle of 120°, as shown in Fig. 19.
Pe not between P1 and P2
19
Figure 19. Conditions necessary for using the Hidden weights programme
The Hidden Weight programme is used on alloy rims, only and exclusively in conjunction
with the ALU 1P/ALU 2P programme:
- when you would rather hide the outer weight behind two spokes for aesthetic reasons.
To use this programme, proceed as follows:
1. Beforehand, select between one of the programmes, ALU 1P, ALU 2P by selecting the
ALU 1P Balancing programme or the ALU 2P Balancing programme icon.
96 Operator's manual EM 9280 - EM 9280 C CompactLine