Corghi CompactLine EM 9280 Manuel D'utilisation page 109

- Keep the Enter
After the list of the utility programmes is displayed:
- select the spin counter icon.
A window where the values of three counters are shown is displayed:
- the first counter value is the overall number of wheel spins performed by the machine
since it was started up for the first time;
- the second counter value is the number of partial spins performed by the machine (it
is reset each time the machine is turned off or by selecting the
- the third counter value is the number of wheel spins performed since the last sensitivity
calibration.
Press the Exit button to no longer display the counters
If the automatic measuring arm fails to operate, the geometric data can be entered manu-
ally by following the procedure below:
- select the manual wheel data entry icon
- the data screen showing the icons is displayed:
manual wheel data change;
unit-of-measurement (inch/mm) change;
displays the help information regarding the current screen.
- select the dimension change icon
- the wheel balancer prepares for manual entry of the width;
- change the displayed value with the value measured with the manual calliper using the
keypad;
Operator's manual EM 9280 - EM 9280 C CompactLine
button pressed as long as desired.
Spin counter function
Manual wheel data entry function
;
;
icon);
.
109
UK