Wheel Data Entry - Corghi CompactLine EM 9280 Manuel D'utilisation

11h
it is possible to remove the wheel that may be present on the machine by proceeding
as follows:
- Close the adjustable drain A (fig. 11h);
- Blow compressed air on the fitting B in the figure 11h
- restore the correct functioning of the wheel locking device by returning the adjustable
outlet A in the above conditions to closing.

WHEEL DATA ENTRY

Wheel data entry for wheel balancers without external mechanical
sensor
The machine allows for the diameter and distance values to be entered automatically; the
width value can be entered using the keypad.
- Bring the automatic measuring arm into contact with the inner side of the rim (Fig.12).
12
Take great care to position the arm correctly so as to ensure accurate data reading.
86 Operator's manual EM 9280 - EM 9280 C CompactLine