Corghi CompactLine EM 9280 Manuel D'utilisation page 95

a
- Repeat the operations to apply the second balancing weight.
- Perform a test wheel spin to check the balancing accuracy.
The rim surface must be perfectly clean to make the weight stick efficiently to the rim.
If necessary, clean the surface using suitable cleansing products.
NOTE: On the wheel balancers for the German market, the weight must be applied as
follows: apply the weight manually by positioning it so that its centre line is 15mm back
from the contact point of the measuring head with the rim.
In the machine versions without a weight-holding
device proceed as follows:
- select the plane where the first balancing weight
is to be applied;
- turn the wheel until the central element of the
corresponding position indicator lights up (if
provided and enabled, the laser line lights up
at the same time);
- apply the adhesive weight manually in the posi-
tion in which the relative plane was measured,
using the centre of gravity of the weight itself as
reference.
The target is shown on the monitor and indicates
the correct application position of the adhesive
weights as shown in figure 18.
• Manually applied adhesive weights without
weight-holder device (Adhesive Weight Ap-
plication Position enabled, CLIP version).
1 Select the first side to be balanced.
2 Turn the wheel until the central element of the corresponding position indicator lights
up. Keeping the wheel in position with the clamping brake, move the sensor until the
two reference lines in the window provided on the screen overlap.
Operator's manual EM 9280 - EM 9280 C CompactLine
b
c
d
e
17
18
95
UK