Wheel Data Entry For Wheel Balancers Version With Automatic Sensor With External Sensor (Width) "If Present - Corghi ProLine 650 Manuel D'utilisation

Take great care to position the arm cor-
rectly so as to ensure accurate data
reading.
- Keep the arm in contact with the rim until
the machine has acquired the wheel's di-
ameter and distance values. The geometric
data are displayed in sequence:
• d distance value;
• di diameter value.
When a geometric value is displayed, the
corresponding LED illuminates on the
display panel.
- Check the values measured and then return
the arm to the rest position. The machine
now presets for WIDTH measurement.
If an incorrect value has been acquired
during the measurement phase, move the
arm to the rest position and then repeat
the operation.
- Measure the width of the rim using the
calliper provided (Fig. 11).
56
- Modify the width value displayed by
pressing the keys
the desired number is set.
The WIDTH can be set in millimetres or
the values already set can be converted
from inches to millimetres by pressing
the
10
Keep the
to rapidly increase or decrease the previ-
ously set values.
WHEEL DATA
ENTRY FOR WHEEL
VERSION WITH
SENSOR WITH
EXTERNAL SENSOR
To enter the distance, diameter and width
values automatically, proceed as follows:
- bring the automatic internal measuring
arm (A, Fig. 7) into contact with the inner
side of the rim as shown in fig. 10 and at
the same time bring the automatic exter-
nal measuring arm (b, Fig. 7) into contact
with the outer side fig. 11a.
11
button.
bALANCERS
AUTOMATIC
(WIDTH) "IF
PRESENT"
User manual ProLine 650
until
keys pressed