Battery Charging (Nimh Battery Pack Only) - MSA Orion G Mode D'emploi

Chapter 4, Setting up the Gas Utility Instrument
Figure 4-1. Removing the Battery
2. Gently pull out the pack by lifting the bottom out of its recess;
then, slide it down.

Battery Charging (NiMH Battery Pack Only)

• Charge the Orion G Multigas and Leak Detector NiMH battery
packs by using the Orion G Fast Charger supplied with the
instrument.
Use of any charger, other than the Orion G Fast Charger
supplied with the instrument, may damage or improperly
charge the batteries.
• The Orion G Multigas and Leak Detector must be turned OFF,
or the battery pack must be removed from the instrument, prior
to charging.
• The charger is capable of charging a completely depleted pack
in two hours in normal, room-temperature environments.
NOTE: Allow very cold battery packs to stabilize for 1/2-hour at
room temperature before attempting to charge.
To Charge the Battery Pack (A.C. Charger 10020551)
• Align and connect charger cable plug and battery pack charging
jack using white alignment markers located on the charger plug
and the back of the battery pack.
• Charger status is indicated by the LED color:
4-2
" CAUTION
Operating Manual