Steba SousVide SV 100 professional Mode D'emploi page 20

Troubleshooting
Problems
Machine does not
work
Water tempera-
ture
does not increase
Water goes on
heating
after the set tem-
perature
is reached.
E01 appears on
the display.
Machine plugs in
and turns on, but
no display in the
LCD.
20
Reasons
∙ Power cord is not plugged
in well.
∙ Problem from the power
supply.
∙ Set temperature below or
close to the water tempera-
ture.
∙ Set heating time is too
short.
∙ Program is wrong.
∙ Temperature sensor is
invalid.
∙ The circulator does not
rotate.
∙ Machine does not be put
into water.
∙ Water level is too low.
∙ The thermic overload is cut
off.
∙ Machine is wrong.
Remedy:
∙ Plug in, turn on the machi-
ne.
∙ Check if the other Machines
work normally.
∙ Check the setting.
∙ Prolong the heating time.
∙ Unplug the device, wait 1
min and plug it in again.
Repaired by the specialist.
∙ Repaired by the specialist.
∙ Put the machine into water
and unplug the device, wait
1 min and plug it in again.
∙ Add water, make sure the
water level is between the
MIN and MAX line.
∙ Open the plastic cover in the
front of the machine, press
"Reset" button.
∙ Repaired by the specialist.