Pressure Relief Procedure - Storch HVLP SmartFinish 360 Mode D'emploi

Pressure Relief Procedure

Follow the Pressure Relief Procedure whenever you see
this symbol.
The spray gun cup is pressurized. To reduce the risk of
splashing from pressurized fluid, always follow the Pres-
sure Relief Procedure before removing cup.
1. Turn the ON/OFF switch to OFF position.
2. Unplug power cord to disconnect power.
3. Disconnect spray gun from air hose.
Setup
When unpacking sprayer for the first time or after long
term storage, perform setup procedure.
1. Connect air hose to sprayer. Hand tighten.
NOTICE:
For units with a whip hose, do not connect whip hose
directly to sprayer. Connect whip hose to gun end.
NOTICE:
The system needs to be airtight for the AUTO-START
function. Use the components supplied along with the tur-
bine and the gun. Make sure that all the hose connections
are firmly attached to avoid any air escaping.
If using a Cup-System:
4. Disconnect tubing from gun to relieve pressure in the
cup.
2. Connect power cord to sprayer power connection.
3. Plug sprayer power cord into grounded outlet.
87 Original instruction