Pressure Relief Procedure; Setup - Storch HVLP SmartFinish 360 Mode D'emploi

Pressure Relief Procedure

Follow the Pressure Relief Procedure whenever you see
this symbol.
The spray gun cup is pressurized. To reduce the risk of
splashing from pressurized fluid, always follow the Pres-
sure Relief Procedure before removing cup.
1. Turn the HVLP sprayer ON/OFF switch to OFF position.
2. Unplug power cord to disconnect power from the HVLP
sprayer.

Setup

Preparation of coating material and the workpiece. Fil-
ter the coating material before spraying.
Use thinner with slightly slower drying characteristics for
turbine spraying systems to compensate for the reduced
drying time caused by the warm turbine air. Do not over
thin.
The output varies depending on the viscosity of the coa-
ting material, the tip size and the hose length.
In order to achieve good adhesion, make sure that the
workpiece is completely clean.
Tip selection
Follow the material manufacturer's recommendation to
select the right tip size.
Original instruction
3. Disconnect spray gun from air hose.
4. If using a Cup-System:
Disconnect tubing from gun to relieve pressure in the cup.
Tip marking
Tips and needles are identified with a marking.
For example: #3. Please note that for the installation
in the gun the marking on the tip and the needle must
match.
Tip sizes:
Marking #2 = 0.8 mm
Marking #3 = 1.3 mm
Marking #4 = 1.8 mm
Marking #5 = 2.2 mm
Other tip sizes available upon request.
78