Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to Spray
The turbine motor generates sparks. These sparks can
ignite flammable fumes.
• Keep sprayer in a well ventilated area.
• Keep sprayer at least 20 feet (6m) from spray area. Use
additional hose if necessary.
Take a few moments prior to spraying and review these
simple tips to ensure your spraying project is a success.
Spray Techniques
First perform a spray test on a test area.
Use the TurboControl function to adjust the pressure.
Always use the lowest pressure required in order to achie-
ve the desired spray pattern and the desired spraying
speed. Spraying at a higher pressure than necessary
wastes material, creates paint mist and can lead to an
orange peel finish.
Aim the gun directly at the surface. Angling the gun to
change the direction of spray will cause uneven applicati-
on.
Uneven finish
thick
thin
Bend arm joint in order to keep gun straight. Fanning with
the gun to adjust the spraying angle results in uneven
application.
Uneven finish
thin
thick
thin
Original instruction
Even finish
even
Even finish
90
Triggering Gun
Pull trigger after starting stroke. Release trigger before
end of strike. Gun must be moving when trigger is pulled
and released.
NOTE:
To prevent uneven spray pattern, start and end stroke off
of work piece surface.
Aiming Gun
Aim center of spray gun at bottom edge of previous stro-
ke, overlapping each stroke by half.
If sprayer does not spray, reference Troubleshooting.
Refilling cup inlet
1. Perform Pressure Relief Procedure.
2. Reference Fill Cup-System
Publicité
Table des Matières
