Storch HVLP SmartFinish 360 Mode D'emploi page 91

Cleanup
Cleaning your sprayer and gun after every job is import-
ant. Proper care and maintenance results in optimal spra-
yer performance.
Cleaning Filters
Cleaning the filters with flammable solvents may cause
the equipment to ignite or explode. Do not use flammable
solvents, such as lacquer thinner, to clean the filters.
The sprayer air filters must be clean at all times to pro-
vide sufficient air flow to cool the motor and atomize the
fluid.
NOTE:
Damage to sprayer can occur if air filters are not cleaned
properly.
NOTE:
The turbine has a TurboControl LED indicator. Indicator
will blink repeatedly to indicate clogged filter.
1. Perform Pressure Relief Procedure.
2. Unplug power cord from power outlet.
3. Remove turbine and motor air filters.
4. Clean air filters and replace as necessary:
• Tap filter gently on flat surface, dirty side down.
• Direct compressed air 2 bar, through filter from the cle-
an side to the dirty side.
NOTICE:
Damage to filter can occur if more than 7 bar is applied.
Soak filter for 15 minutes in water and mild detergent.
Rinse filter until clean. Air dry.
Cleaning the Cup-System
NOTICE:
Solvents, such as lacquer thinner, can damage parts
of the Cup-System. Do NOT immerse parts of the Cup-
System in solvent.
1. Perform Pressure Relief Procedure.
2. Disconnect gun from Cup-System.
91 Original instruction