Storch HVLP SmartFinish 360 Mode D'emploi page 93

10. Cover cup fitting (2a) with a rag, shake the entire Cup-
System for a minimum of ten seconds.
11. Wipe clean and dry all components of Cup-System.
Properly dispose of cleaning fluid.
Cleaning the gun
NOTICE:
Solvents, such as lacquer thinner, can damage parts of
the gun. Do NOT immerse parts of the gun in solvent.
1. Remove retaining ring and air cap.
2. Trigger the gun and remove fluid nozzle from gun.
NOTICE:
Guns contain air cap guide and spring held in place by
fluid nozzle. Upon removal of fluid nozzle, set aside air
cap guide and spring.
NOTICE:
Trigger the gun whenever removing or installing the fluid
nozzle. This prevents the fluid nozzle and needle seating
surfaces from being damaged.
3. Move trigger slide from SPRAY position (A) to NEED-
LE REMOVAL position (B).
SPRAY
Position
93
NEEDLE
REMOVAL
Position
Original instruction