Storch HVLP SmartFinish 360 Mode D'emploi page 88

Fluid and Work Piece Preparation
• Strain fluids before spraying. This includes colors,
reducers and hardeners.
• Use a slower drying reducer or thinner to compensate for
the faster drying time caused by the warm air of the turbi-
ne. Do not over reduce.
• Sprayer performance varies with the viscosity of the
material sprayed and the length of the hose. To prevent
pressure drop, use hose supplied with sprayer.
• Most material manufacturers provide recommendations
for their materials. Follow these recommendations.
• For proper adhesion, ensure surface of work piece is
completely clean.
Startup
Fill the Cup-System
1. Disconnect gun from Cup-System.
2. Loosen ring from cup. Remove cover and ring from cup.
Verify cup inlet remains in cup upon removal of cover and
ring.
Original instruction
Select the nozzles combination
For best spray performance, select proper fluid set for
fluid being sprayed. Reference Fluid Set Selection Guide
in gun manual provided with sprayer. Nozzle numbers are
marked on fluid needles and nozzles.
3. Fill cup inlet with material to "MAX FILL" line. Clean
threads and sealing surfaces of Cup-System.
4. Install cover and ring onto cup. Tighten ring securely.
88