Description Of Cabling/Modular Contacts; Self-Inspection Of The Installation - Tylo Sense Combi-U 7 Notice D'installation Et D'utilisation

10

Description of cabling/modular contacts

Pos 1. Pos 2. Pos 3.
NTC Ext sw Door sw
Pin 1: Pin 1: Pin 1:
Pin 2: NTC Pin 2: LED Pin 2: LED
Pin 3: NTC Pin 3: SW Pin 3: SW
Pin 4: Pin 4: 12 V Pin 4: 12 V
1 2
Pos 6-9.
4x RS485 6 7
Pin 1: A
Pin 2: B
Pin 3: 12 V
Pin 4: GND
Figure 21: Modular contacts, description (Pos 1-4 and 6-9: RJ10, Pos 5: RJ45)
1. NTC Sensor - Combi Pure.
2. Ext switch (External switch Optional)
3. N/A
4. N/A
5. N/A
6. Sensor (humidity- and temperature) - Combi Elite.
7. N/A
8. N/A
9. Controls panels (Pure or Elite).
10. Modular plug (RJ10)
11. Modular contact (RJ10)
Table 3: Connecting components in modular contacts (maximum cable area for RJ10: 0.90 mm/0.20 mm², AWG24)
Connection of
Combi Pure Temp. sensor (10kohm)
External switch with no wire indicator 2
External switch with wire indication
NOTE! Crimp pliers are needed if changing modular
cabling, e.g. shortening wires.

SELF-INSPECTION OF THE INSTALLATION

To check the installation:
1. Turn power on at the Circuit Breaker Box.
2. Check that the control panel lights up.
3. Start the heater (see User Guide).
4. Check that all three tubular elements start to heat up (go
red).
Pos 4. Pos 5.
Bim/NTC Addon (option)
Pin 1: Bim
Pin 2: NTC
Pin 3: NTC
Pin 4: Bim
3 4 5
8 9
Pos
1
2
10
Pin: 1 2 3
Pin Comment
2-3 Must be NTC model.
3-4 Both constant or impulse deactivation works.
2-3-4 12VDC (max. 40mA).
Please keep these instructions!.
In the event of problems, please contact the retailer where you purchased
the equipment.
© This publication many not be reproduced, in part or in whole, without
the written permission of Tylö. Tylö reserves the right to make changes to
materials, construction and design.
Pin: 4 3 2
11
4
1