Modular Connector Description - Tylo 2900 4160 Mode D'emploi

During operation the steam generator is emptied automatically after 4 hours (factory setting, via settings > auto emptying can be
altered) in order to ensure good water quality. When 2 or 3 generators are connected together, the "Secondary"-generators are
emptied at 20 minute intervals after the "Primary" has been emptied.
The connections between the generators use a low power cable (4 core) with an RJ10 connector, (Fig. 18.)
Refer to the section "Modular connector description" (Fig.18) for more information on the pin configuration.
Fig. 18
*= option
If one steam generator needs servicing the others can remain in operation. One generator that is set as a secondary is
disconnected by removing the cable from between the circuit boards. (Fig. 18)
If the generator that is to be serviced is set as the "primary), do as follows:
1. Use the circuit breaker to switch off the generator.
2. Disconnect the cable that connects the control circuit boards (Fig. 18)
Select a "secondary" steam generator and change the DIP switch settings to "primary" according to the appropriate type.
3.
Refer to Fig. 17. Then connect the control panel to the new "primary". A new "initial setup" will be requested, as the generator
had not been set up as a "primary" earlier.

Modular connector description

Fig. 19
1. NTC Sensor (RJ10)
2. External switch (RJ10)
3. Door contact (RJ10)
4. SEC/NTC Sensor (option) (RJ10)
5. Add on (option for Home)(RJ45)
6. RS485 control panels (RJ10)
7. RS485 control panels (RJ10)
8. RS485 control panels (RJ10)
9. RS485 control panels (RJ10)
10. Modular plug (RJ10)
11. Modular contact (RJ10)
29