Remove Residue From The Frying Process; Remove Lime; Clean Stainless Steel Surfaces; Errors And Remedies - Salvis ProfiLine GN 2/1 Mode D'emploi

en
7.2

Remove residue from the frying process

. Turn off appliance and let it cool down.
. Fill the bratt pan with approximately 5 litres of warm water. Add rinsing agent and vinegar cleaner
and clean with a cleaning brush or with a stainless steel pan cleaner.
. Tip out the residue from cleaning.
. Remove dark spots on the surface with vinegar cleaner and stainless steel pan cleaner.
. Thoroughly rinse the bratt pan with water and rub dry.
. Spray the bratt pan using food quality maintenance emulsion. Distribute the cream cleaner evenly
with a kitchen towel.
. Only for extended pauses during operation: In order to prevent the frying surface from becoming
corroded, apply a thin film of edible fat or oil to the frying surface. Allow the edible fat or oil to
burn in for a period of approx. 10 minutes at 200°C. During the heating process, switch on the
exhaust hood or well ventilate the room.
7.3

Remove lime

. Turn off appliance and let it cool down.
. Fill up the bratt pan with vinegar and water at a ratio of 1:1 (1 part vinegar to 1 part water). Boil
briefly and allow to react for 15 to 30 minutes, depending on the limescale deposit.
. Tip out the residue from cleaning.
. Thoroughly rinse the bratt pan with clear water and rub dry.
. Spray the bratt pan using food quality maintenance emulsion. Distribute the cream cleaner evenly
with a kitchen towel.
. Only for extended pauses during operation: In order to prevent the frying surface from becoming
corroded, apply a thin film of edible fat or oil to the frying surface. Allow the edible fat or oil to
burn in for a period of approx. 10 minutes at 200°C. During the heating process, switch on the
exhaust hood or well ventilate the room.
7.4

Clean stainless steel surfaces

. Clean stainless steel surfaces with grease-dissolving cleaner or a special stainless steel cleaner.
. Wash or rinse the cleaned surfaces thoroughly with clean water and dry with a soft cloth.
8.

Errors and remedies

If faults should occur, check them using the following table:
Fault
No response appears
on the display screen
after switching on the
appliance.
44 / 76
Possible cause
Main switch in building
not switched on before
switching on the appli­
ance.
There is no power sup­
ply at all.
Mains fuse on site has
tripped.
Remedy
Turn on main switch.
Inform the power supply company.
Possible faults on the appliance must be
checked by an authorised Customer Ser­
vice agent.
Reset the circuit breaker.