Changing Control Default Settings; Setting The Parameter; Parameter Table - Salvis ProfiLine GN 2/1 Mode D'emploi

en
5.10

Changing control default settings

5.10.1

Setting the parameter

Depending on the equipment of the appliance, different setting options are possible for the control.
Refer to the following parameter table Chapter 5.10.2.
The setting mode is automatically switched off if key "P"
pressed within 10 seconds. Settings that were not confirmed by pressing the key "P" are not stored.
Changing the setting
● The appliance must beswitched on.
. First, press and hold the key "P"
taneously hold both for 3 seconds.
● The parameter set last will be displayed.
. Within 10 seconds, keep pressing the "up"
displayed.
. Within 10 seconds, press the "P"
● The value of the parameter flashes.
. Within 10 seconds, keep pressing the "up"
set.
. Storing the set value - within 10 seconds, press the key "P"
Exiting the setting process
. Wait for 10 seconds - the "setting the parameters" function is switched off.
Or:
. First, press and hold the key "P"
ture/tilt"
5.10.2

Parameter table

Param
eters
P02
P03
P04
P05
P06
P07
P08
42 / 76
Factory
setting Setting range
1 0=off, 1=on
10 seconds 0-60 seconds
0 0=off, 1=on
30 minutes 10-120 minutes
110°C 60-170°C
1 0=1°C, 1=5°C
0 0=off, 1=on
or key "Up"
, then press the key "Actual temperature/tilt"
or "down"
key.
or "down"
then, simultaneously, briefly press the key "Actual tempera­
Description
Switching the acoustic signal and key sound
on or off
Switching acoustic signal off (0) and setting
length of the acoustic signal (1-60 seconds)
Switching the standby function on or off
Starting the standby function after x minutes
Standby temperature bratt pan
Temperature adjustment in increments each
time key is pressed
Switching the cooking time correction on or off
or "Down"
- and simul­
key until the desired parameter is
key until the desired value has been
are not
Customer
setting