General Information; Safety - DT SWISS L2 Remote Lever Manuel D'utilisation

Congratulations on the purchase of your new DT Swiss remote lever! You have purchased a quality
product made by DT Swiss.

1. GENERAL INFORMATION

This user manual is intended for the user of the remote lever. It includes information on the assembly,
maintenance and care.
For further information and activities refer to www.dtswiss.com.
Users must read and understand this manual before using the component. Third-party users must
also be informed about the following provisions. Keep this user manual handy / for reference in case
you need to refer to it later.

2. SAFETY

NOTE
Incorrect handling, incorrect installation and incorrect maintenance or care can lead to
malfunctions or damage!
• Compliance with the following provisions is a prerequisite for accident-free use and faultless
performance.
• Assembly and maintenance of the remote lever requires a basic knowledge of handling bicycle
components. If in any doubt, consult your retailer.
• After assembly, the cable must be at least long enough to allow the handlebars to be turned
freely without the cable becoming too taut.
• The remote lever must be compatible with all parts of the bicycle.
• Only use original DT Swiss spare parts.
• The remote lever must not be changed or modified.
• The remote lever must not be used if it is damaged or there are any signs of damage. If in any
doubt, consult your retailer.
2.1 COMPATIBILITY
The L2 Remote Lever is compatible with DT Swiss forks and shocks. The L3 Remote Lever is also
compatible with DT Swiss dropper seat posts.
Compatibility with components from other manufacturers may be possible, but DT Swiss gives no
functional guarantee and offers no support.
L2 / L3 Remote Lever
9