Replacing Mounting Pin On 70°, 80° And 90° Front Rigging - Invacare MyOn Active Manuel De L'utilisateur

1 FRONT RIGGINGS
1.5 Replacing Mounting Pin on 70°, 80° and 90° Front
Rigging

For this procedure, refer to FIGURE 7.
1. Remove the front rigging (A) from wheelchair (B).Refer to
Installing/Removing Front Riggings on page 89.
2. Remove mounting screw (C) that secures the mounting pin (D) to
the front rigging (A).
3. Remove mounting pin (D) from front rigging (A).
4. Install new mounting pin (D) into front rigging (A).
5. Secure new mounting pin (D) to front rigging (A) with mounting
screw (C). Securely tighten.
6. Install front rigging (A) onto wheelchair (B). Refer to
Installing/Removing Front Riggings on page 89.
™
Invacare® MyOn
B
FIGURE 7 Replacing Mounting Pin on 70°, 80° and 90° Front Rigging
46
D
A
C
Part No 1167417