Section 5 - Seat And Back; Replacing The Slip On Back Upholstery; Removing/Installing Padded Seat - Invacare 6895 Manuel De L'utilisateur

SEAT AND BACK
Section 5 - Seat and Back - includes the following:

Replacing the Slip On Back Upholstery

Removing/Installing Padded Seat

After ANY adjustments, repair or service and BEFORE use, make sure all at-
taching hardware is tightened securely - otherwise injury or damage may occur.
When installing the seat, ensure ONLY open palms (and not fingers) are
used to press down on the seat to lock on frame. Otherwise injury or
damage may occur.
REPLACING THE SLIP ON BACK UPHOLSTERY (FIGURE 1)
1. Remove the two (2) mounting screws
and washers that secure the existing
back upholstery to two (2) back canes.
2. Pull existing back upholstery up and
over the two (2) back canes.
3. Install the NEW back upholstery
over the two (2) back canes.
4. Secure the NEW back upholstery to
the back canes with the existing
mounting screws and washers.
REMOVING/INSTALLING PADDED SEAT
REMOVING (FIGURE 2)
The padded seat may be positioned in one (1) of four (4) directions (DETAIL "A" of
FIGURE 2).
1. Move armrests out of the way by squeezing the armrest release lever and lifting.
2. Remove seat by pulling up on seat.
FIGURE 2 - REMOVING/INSTALLING PADDED SEAT
Part No. 1118394
All manuals and user guides at all-guides.com
WARNING
Mounting
FIGURE 1 - REPLACING THE SLIP
19
Using Seat Cover
Removing/Installing Seat
Positioning Strap
Washer
Screws
ON BACK UPHOLSTERY
DETAIL "A"
1
4
3
Rehab Shower Commode Chair
SECTION 5
Back Upholstery
Back Cane
2