Anti-tippers
6.2
Adjusting Anti-Tippers
For this procedure, refer to FIGURE 2.
WARNING
When anti-tippers are used, anti-tippers MUST be
adjusted to maintain a 1
between the bottom of the anti-tipper wheels and
the ground/ floor. This spacing should always be
checked whenever adjustments/changes are made
to the wheelchair. Failure to maintain proper
spacing may result in the chair tipping over
backward causing serious injury or property
damage.
1.
Press the release buttons (A) on the wheeled portion of the
anti-tipper and slide it up or down to achieve the 1
clearance.
2.
Check to make sure that the release buttons are fully engaged in
adjustment holes.
™
Invacare® MyOn
1
/
to 2 inch clearance
2
1
/
to 2-inch
2
A
FIGURE 2
80
1
1
/
to 2 inch
2
Clearance
Adjusting Anti-Tippers
Part No 1167417