Replacing Handrims - Invacare MyOn Active Manuel De L'utilisateur

3 REAR WHEELS/FRONT CASTERS
6. Repeat STEPS 4-5 until the quick release axle detent pins are fully released past the wheelchair frame.

3.3 Replacing Handrims


For this procedure, refer to FIGURE 4.
1. Remove the rear wheel from the wheelchair. Refer to
Removing/Installing Rear Wheels on page 58.
2. Remove the mounting screws (A) that secure the existing handrim
(B) to the rear wheel (C).
3. Remove the existing handrim.
4. Install the new handrim and secure to the rear wheel with the
existing mounting screws.
5. Reinstall the rear wheel to the wheelchair. Refer to
Removing/Installing Rear Wheels on page 58.
6. Repeat STEPS 1-5 for opposite wheel, if necessary.
Invacare® MyOn™
D
FIGURE 3 Adjusting Quick-Release Axles
E
A
C
B
C
B
FIGURE 4
62
A
Replacing Handrims
Part No 1167417