Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
bottom table with the previously installed screw to
assemble the cover plate located on the back of the
bottom table and complete the replacement.
50. FULL ASSEMBLY REVIEW
•
It is highly recommended to wipe the exterior of your
unit clean of debris, dirt, etc., using warm soapy water
and a soft cloth.
•
Remove all advertising and any glue residue.
•
Use a vinegar and water solution to clean the glass on
the smoker. Do not use a glass cleaner as this will leave
a film on the glass, which could bake on.
GAS AND REGULATOR
This barbecue can use either propane or butane or propane/ butane mixed LPG (liquid petroleum gas) bottled gas. Propane
bottles, will supply gas all year round, even on cold winter days. Butane bottles will supply sufficient gas in summer, but it
may affect the performance of the barbecue and restrict the heat output available from the burners, particularly once the gas
temperature starts to fall below +10°C. A spanner may be required to change gas bottles.
•
The hose should hang freely with no bends, twisting, tension, folds, or kinks that could obstruct free flow of gas. Always
inspect the hose for cuts, cracks, or excessive wear before use.
•
Apart from the connection point, no part of the hose should touch any hot barbecue parts. If the hose shows any sign of damage it
must be replaced with a hose suitable for use with LP gas which meets the national standards for the country of use.
•
A suitable hose must comply with EN16436-1, and the length should not exceed 1.5 meters.
For optimal performance, we suggest to use a 5-15kg gas bottle.
SAFETY AND CARE ADVICE
The maximum dimension of the gas bottle is dia 31.5cm and height 58cm.
Never mount the gas bottle under the barbecue on the base shelf as this could result in serious
injury to the user, other people and/or property. Always place the gas bottle at the left or right
hand side of the appliance. The gas bottle should be sited as far away from the appliance as
possible without straining the hose.
This appliance is only suitable for use with low-pressure butane or propane gas and fitted with the
appropriate low-pressure regulator via a flexible hose. The hose should be secured to the regulator
and the appliance with hose clips/nut. This barbecue is set to operate a 28-30 mbar regulator with
butane gas or a 37mbar regulator with propane gas. Use a suitable regulator certified to EN16129.
Please consult your LPG dealer for information regarding a suitable regulator for the gas cylinder.
GAS CYLINDER REQUIREMENTS
The grill is set and tested with liquid propane gas only. The regulator supplied is set for 27.94 cm (11 inch) water column (WC) and is for use
with LP gas only. The factory-supplied regulator and hose must be used with a 9 kg (20 lbs) LP gas tank. Contact your gas supplier for a
special regulator for bulk gas that fuels other appliances.
CAUTION: It is important to inspect the full length of the gas line hose. If it is evident there is excessive abrasion
or wear, or the hose is cut, the hose must be replaced prior to the appliance being used.
CONNECTING TO A GAS SUPPLY
FIG. 50
2
1
Key
1= maximum diameter
2= maximum height
29
Publicité
Chapitres
Table des Matières
