Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
43. INSTALLING WARMING RACK (CHARCOAL GRILL)
Parts Required :
1
x
Warming Rack (#5 )
1
x
Charcoal Lid
1
x
Charcoal Main Chamber
M6x30 mm Screws (#M)
2
x
Installation :
•
Screw 1 x M6x30 mm Screw through the Charcoal Lid from
the outside, position 1 pc Warming Rack to the charcoal
grill so that the screw is going through the wire loop.
See Fig. 43.1 and Fig. 43.2.
•
Then align the wire loop on the opposite end of the
Warming Rack with the opposite Lid hole and insert 1 x
M6x30 mm Screw . Insert the wire legs into the holes of
the Charcoal Main Chamber.
See Fig. 43.3.
44. PLACING COOKING GRIDS
Part Required :
Cooking Grids (#30 )
4
x
Installation :
•
Place four Cooking Grids into the Cooking Grid Support.
See Fig. 44.
45. INSTALLING LID THERMOMETERS
Parts Required :
2
x
Thermometers (#1)
Thermometer Bezels (#2)
2
x
1
x
Gas Lid
1
x
Charcoal Lid
Note: The Thermometer is supplied with one fiber
washer and one wing nut.
Installation :
•
Unscrew the wing nut and washers from the 2 pcs
Thermometer first. Insert Thermometer probe through the
Bezel and the mounting hole in the top of the Gas Lid Assembly.
from the inside of the lid, place fiber washer and wing nut onto
the mounting thread pole and tighten by hand.
See Fig. 45.
•
Repeat the same step for Charcoal Lid.
FIG. 43.1
M
FIG. 43.2
FIG. 44
FIG. 45
1
2
M
5
FIG. 43.3
30
30
1
2
27
Publicité
Chapitres
Table des Matières
