Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONNECTION FOR CONNECTOR
Note: The connector kit is not included if the regulator is pre-assembled.
CONNECTOR A
Connector A for Countries: BE, CZ, SK, SL, DK, IE, GB, IS,
LU, CO, RO, MLT, CYP, LTU, EST, LVA, ISR, ES, PT, FI, NO, GR,
IT, SE, BUL, HU
CONNECTION FOR CONNECTOR A
1.
Insert connector tapered end into the regulator tube, then lock tight
by using the hose clamp. See A1.
2. Loop in the connector into the metal ring, then into the manifold,
tightening completely. See A2.
Note: if there's no metal ring included, ignore this step.
3.
Connect the regulator to the gas cylinder, open the cylinder making
sure the knob is in the OFF position. Spread soapsuds all over the joint
between the connector and the regulator tube, and between the manifold and the connector. Check if there's any gas leakage. If
leakage is found, tighten the connector or the manifold again until there is no leakage observed.
CONNECTION FOR CONNECTOR B
1.
Screw in the male connector threaded end into the regulator tube
threaded female end. Tightening completely. See B1.
2. Loop in the connector into the metal ring, then into the manifold,
tightening completely. See B2.
Note: if there's no metal ring included, ignore this step.
3.
Connect the regulator to the gas cylinder, open the cylinder making
sure the knob is in the OFF position. Spread soapsuds all over the joint
between the connector and the regulator tube, and between the manifold and the connector. Check if there's any gas leakage. If
leakage is found, tighten the connector or the manifold again until there is no leakage observed.
INSTALLING A GAS CYLINDER
1.
From the side of the cart, rest the 9 kg (20 lbs) tank onto the ground. Make
sure the tank valve is in OFF position. Ensure the tank is completely upright,
as it is unsafe to operate the grill if the gas tank is not installed properly.
2. Ensure the regulator valve on the grill is completely closed by turning the
knob clockwise to the OFF position.
3.
Remove the protective caps from the regulator valve opening and the top of
the gas cylinder. Save the caps.
4. Insert the gas cylinder valve into the threaded opening of the regulator
valve. Turn the cylinder clockwise until firm. Hand-tighten only. Fig 1.
5.
Gas cylinder is now installed.
PREPARATION FOR USE – LEAK TESTING:
WARNING: NEVER USE YOUR GRILL WITHOUT LEAK TESTING ALL GAS CONNECTIONS, HOSES AND PROPANE TANK.
30
CONNECTOR B
Connector B for Countries: FR
A1
B1
A2
B2
FIG. 1
Publicité
Chapitres
Table des Matières
