Propane Gas Unit; Charcoal Unit - Pit Boss PBMEMUU001 Instructions D'assemblage Et D'utilisation

PROPANE GAS UNIT

SYMPTOM
Burner will not light or stay alight
Irregular flame pattern. Flame does
not run the full diameter of burner
Flame is yellow or orange

CHARCOAL UNIT

SYMPTOM
Low heat / Low Flame
Excessive Flare-ups / Uneven Heat
"Paint" appears to be peeling
inside lid or hood.
42
CAUSE
No gas flow
Obstruction of gas flow
Faulty Hose Valve Regulator
Burner is off the valve
Spider webs or obstruction in burner tube Clean burner tube. Use a soft wire brush to clear plugged ports
Burner ports blocked
Faulty Burner
Bad igniter spark
Burner ports blocked
Burner may be blocked
Spider webs or obstruction in burner tube
Food residue or grease on burner
Burner is off the valve
Fuel/Air mixture incorrect
Burner may have residue
CAUSE
Improper pre-heating
Not enough airflow
Low Charcoal
Improper Charcoal Tray Height
Improper Pre-heating
Excessive grease and ash build up in the
ash/drip pan
Improper Charcoal Tray Height
Grease Build up on the inside surfaces
SOLUTION
Confirm LP Gas cylinder is full and valve is turned to "open".
Check for bent or kinked regulator
Clean burner ports.
Call for replacement.
Re-engage burner onto the valve.
Clean burner ports.
Call for replacement.
Check to see if electrode is producing spark. The spark should
be visible and jumping from the igniter to the burner. If you
cannot see any spark you may need to slightly adjust the
position by bending the electrode a little closer or further
away from the burner. Replace igniter or replace the igniter
wire. Call Dansons for replacement.
Check to make sure your battery in your igniter is good.
Refer to owners manual for replacement. Check to see if
burner will match light.
Clean burner ports. Use a soft wire brush to clear
plugged ports
Clean burner ports.
Clean burner tube.
Clean burner.
Re-engage burner onto the valve.
You may need to adjust the primary air shutter to allow
more air into the burner
Turn burner to high setting for 5 minutes and burn with
the door open.
SOLUTION
Allow charcoal to burn until covered with a light gray ash
(usually 20 - 25 min.)
Open vents wide
Check and clean vents or exhaust openings
Add more charcoal to the charcoal tray. Stand back a
safe distance and use long tongs.
Raise charcoal tray to the highest position.
After lighting, Preheat grill with main lid closed for 20-25 min.
Clean ash/drip pan regularly. Do not line pan with
aluminum foil. Refer to cleaning instructions.
Lower Charcoal tray to lowest position.
This is not a defect. The peeling is caused by hardened
grease, which dries into paint-like shards that will flake off.
Regular cleaning will prevent this. See cleaning instructions.