ETS 300
11 Technical specifications
Input data for built-in sensor
Measuring range
Probe length
Pressure resistance
Mechanical connection
Torque value
Parts in contact with medium
Input data for separate sensor
1)
Measuring range
Connection, separate temp. probe
Output data
Accuracy (display, analogue output)
Temperature drift (environment)
Analogue output (optional)
Signal
Switching outputs
Type
Switching current
Switching cycles
Rise time acc. to DIN EN 60751
Ambient conditions
Ambient temperature range
Storage temperature range
Fluid temperature range
for the probe (for built-in sensor)
-mark
Vibration resistance to
DIN EN 60068-2-6 (0 .. 500 Hz)
Shock resistance to
DIN EN 60068-2-29 (1 ms)
Protection class to IEC 60529
Other data
Supply voltage
Current consumption
Residual ripple of supply voltage
Display
Weight
Note.: Reverse polarity protection of the supply voltage, excess voltage, override, short circuit
protection are provided. FS (Full Scale) = relative to the complete measuring range
1) Depending on the temperature range of the temperature sensor fitted, this can reduce the
display range of the ETS 300 with a separate sensor input.
2) -25 °C with FPM seal, -40 °C on request.
Status: 29.01.2014
2)
HYDAC ELECTRONIC GMBH
-25 .. 100 °C (-13 .. 212 °F)
18 mm
600 bar
G1/2 A DIN 3852
45 Nm
Mech. conn.:
stainless steel
Seal:
FPM
-30 .. 150 °C (-22 .. 302 °F)
Female cable connection M12x1, 4-pole
≤ ± 1.0 °C (≤ ± 2.0 °F)
≤ ± 0.015 % FS / °C max. zero point
≤ ± 0.015 % FS / °C max. range
4 .. 20 mA, ohmic resistance ≤ 400 Ω
Corresponds to
-25 .. +100 °C with built-in sensor
-30 .. +150 °C with separate sensor
PNP transistor switching outputs
max. 1.2 A per output
> 100 million
t
= 3s / t
= 9s
50
90
-25 .. +80 °C
-40 .. +80 °C
-40 .. +100 °C / -25 .. +100 °C
EN 61000-6-1 / 2 / 3 / 4
≤ 10 g
≤ 50 g
IP 65
20 .. 32 V DC
approx. 100 mA without switch output
≤ 5 %
3-digit, LED, 7 segment, red,
height of digits 9.2 mm
̴ 300 g
13
Part No.: 669651 E