SOMFY DEXXO PRO io Manuel D'installation page 44

Dexxo Pro io
ATTENTION
parts.
- the mechanism is correctly adjusted
- the manual back release device is operating correctly
- the motorisation changes direction when the door
encounters an object 50 mm high on the ground.
photoelectric cells must be installed.
required to comply with the regulations in the country in
which the motorisation is installed.
> Clothing precautions
installation.
1.6 Regulations
Somfy declares that the product described in these
complies with the essential requirements of the applicable
1.7 Assistance
installing your motorisation.
Do not hesitate to contact us; our specialists are on hand to
1.8
Risk prevention - motorisation of sectional/up and
over garage door for residential usage
Zone 4
Zone 5
Zone 4
WARNING
WARNING
Zone 2
Zone 1
Zone 1
Zone 4
RISK SOLUTION
Obstacle detection built into
the motorisation. It must be
imperatively checked that the
between the ground
obstacle detection complies with
and the lower edge
of the door during
closing
For operation with automatic
(see installation manual)
Obstacle detection built into
the motorisation. It must be
imperatively checked that the
between the lintel and
obstacle detection complies with
the upper edge of the
door during closing
Eliminate all sticking points and
all sharp edges from the surface
of the door
trapping between the
door panels in gaps
of between 8mm and
25mm
Eliminate all sharp edges on the
guide rails
between the roller rails
and bearings between the rails and the
bearings
Obstacle detection built into
the motorisation. It must be
imperatively checked that the
between the
obstacle detection complies with
secondary edges and
than 2.5 m above the ground or any other permanent
access level.
Copyright © 2015 SOMFY ACTIVITES SA. All rights reserved
Zone 2
Zone 5