Keytis Remote Control Description; Keygo Remote Control Description; Fitting The Battery For Keytis Remote Controls - SOMFY DEXXO PRO io Manuel D'installation

Dexxo Pro io
[3]. Adjust the closed position using the "+" or "-" buttons.
Release the "-" button before the motor has time to force against
the door.
[4]. OK
learning cycle.
The door runs through a complete Open Close cycle.
-
-
S1
-
the learning mode.
- SET
At the end of installation, it must be checked that the obstacle detection
complies with annex A of the standard EN 12 453.

4.3 Keytis remote control description

1 - Individual control buttons
2 - STOP button
3 - CLOSE
4 - Operation indicator light On
5 - Low battery indicator light
6 - Closing clip
7 - PROG
8 - KEY

4.4 Keygo remote control description

1 - Individual control buttons
2 - Operation indicator light On

4.5 Fitting the battery for Keytis remote controls

4.6 Programming Keytis remote controls - Fig. 18 to 22
with at least one programmed remote control
remote control, then go straight to Programming the
Keytis remote control step (Fig. 20 to 22).
7
C1
C1
WARNING
Intermittent Blinking
Intermittent Blinking
remote control by copying another Keytis remote control are only
remote control must be able to establish radio communication with
an installation receiver.
> Memorising the system key (Fig. 19).
[1].
- Keytis, Telis, Impresario, Composio
KEY
-
[2]. KEY
> Programming the Keytis remote control (Fig. 20 to 22)
memorised the system key.
Each control button is programmed individually.
A button that is already programmed cannot be programmed on a second
-
-
Keytis remote controls.
- Programming from a Dexxo Pro motor.
- Programming by copying a previously programmed Keytis remote
control.
> Programming from a Dexxo Pro motor (Fig. 20)
[1]. PROG
seconds).
[2]. PROG
quickly.
This may take from a few seconds to around a minute depending on the
number of products connected to the system.
[3].
> Programming by copying a previously programmed Keytis
remote control
Completely copy the programming of a Keytis remote control (Fig. 21)
This operation is used to copy all of the buttons programmed from an already
programmed remote control.
[1]. PROG
until the green indicator comes on (two seconds).
[2]. PROG
rapidly (a few seconds).
Individually copy the programming of a Keytis remote control button
(Fig. 22)
This operation is used to copy the programming of a single button from an
already programmed remote control.
[1]. PROG
until the green indicator comes on (two seconds).
[2].
control.
[3]. PROG
[4].
control.
Copyright © 2015 SOMFY ACTIVITES SA. All rights reserved
Clearing