Filling The System; Switching On When In Continuous Operation; Setting The Fineness Of The Coffee Mill - Rotel AroMatica 762 Mode D'emploi

•
Press the right control knob (3) until «Level 3» is blinking.
•
Turn the right control knob (3) to the desired level.
•
Press the control knob to confirm the entry.
•
«Please rinse» appears in the display. Press the right control knob (3).
•
The system will now be rinsed.
•
The main menu will appear on the display as soon as the system is ready for oper-
ation.

Filling the system:

As the machine is still fresh from the factory, it is possible that the water lines in the
appliance may not yet be filled with water when you use it for the first time. The appli-
ance will indicate this as follows:
•
Once the appliance has been switched on with the main power switch (6),
the display shows «System füllen» (Filling the system).
•
Place a sufficiently large receptacle (approx. 0.5 l) under the outlet (4).
•
Press the right control knob (3). The system will now be filled and some water could
drip out of the outlet.
•
The command «Bitte spülen» (Please rinse) appears once the system has heated up.
•
Press the right control knob (3). The system will now be rinsed.

2.4 Switching on when in continuous operation

All the steps mentioned above are only carried out during the very first operational
start-up. Proceed as follows for all the subsequent switch-on procedures:
•
Switch on the appliance with the main power switch (6).
•
«System is heating» appears in the display, followed by «Please rinse».
•
Place a receptacle under the outlet (6) and press the right control knob (3).
•
The system will be rinsed.
•
The main menu will appear on the display as soon as the system is ready for oper-
ation.

2.5 Setting the fineness of the coffee mill

Please note
The fineness setting may only be adjusted when the coffee mill is in operation.
You can adjust the grinder to suit the roast of your coffee beans. We would recom-
mend, however, that you leave the coffee mill at the medium setting.
42
13_0944_ROT_BA_U2762CH_IH.indd 42 13_0944_ROT_BA_U2762CH_IH.indd 42 14.10.13 09:37 14.10.13 09:37