Memory Card - Spypoint BF-10HD Manuel D'utilisation

6
POWER
The battery level is shown in the bottom right corner of the
screen when the camera is in "TEST" mode. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The use
of alkaline or lithium batteries is strongly recommended. Also
note that the voltage of rechargeable AA batteries (1.2V)
is insufficient to power your SPYPOINT
the installation of the AA batteries, slide the switch inside
the battery case to "ALK". Insert the batteries as indicated
inside the battery case. Exact polarity must be followed. We
also recommend the use of new batteries to ensure maximum
performance of your camera.
Lithium battery pack
This camera SPYPOINT
lithium battery pack LIT-09/LIT-C-8 (sold separately, refer to
the section "OPTIONS"). This type of battery is less affected by
cold temperatures and lasts up to 3 times longer then an alkaline
battery. During the installation of the lithium battery pack, slide
the switch inside the battery case to "LIT-09".
External (12V)
This camera can also be powered from an external 12-volt
DC input such as a 12-volt battery (KIT-12V/BATT-12V, sold
separately) or a 12-volt adapter (AD-12V, sold separately).
During the installation of a 12-volt connection, slide the switch
inside the battery case to "ALK" (the AA batteries can remain
safely inside the camera). If combined with a lithium battery
pack, slide the switch to "LIT-09". For the accessories available,
refer to the section OPTIONS.
camera. During
®
® can be powered by a rechargeable
Solar panel
This model also offers the possibility of a connection to a solar
panel SP-12V (sold separately, refer to the section "OPTIONS")
to maintain the charge of the lithium battery pack (sold
separately, refer to the section "OPTIONS") or the 12-volt
battery (sold separately, refer to the section "OPTIONS").
During the installation of the rechargeable lithium battery pack
or 12-volt battery, slide the switch inside the battery case to
"LIT-09" to activate the charging system of the solar panel.
Power source
• 6AA
• 12V
• 12V + 6AA
• LIT-09
• 12V + LIT-09
• Solar panel + LIT-09

MEMORY CARD

Using a memory card (sold separately, refer to the section
"OPTIONS") is required to operate the camera. When the
camera is "ON" and no memory card is used, the screen displays
"Insert memory card". The camera has a 32 GB memory
capacity. Before inserting or removing the memory card, the
camera must be turned "OFF". Failing to do so may cause loss
of or damage the pictures already recorded from the memory
card. When the SD card is full, the viewing screen indicates
"Disk Full". The following data shows an approximate quantity
of photos or video length that can be taken by the camera
depending on the memory card capacity.
RESOLUTION 2.0Go
3 MP 2000
5 MP 1700
10 MP 1000
VIDEO 2.0Go
RESOLUTION
1280 x 720 (720p) 20 min
Switch position
ALK
LIT-09
4.0Go 8.0Go 32Go
4100 8200 32800
3400 6800 27300
1900 3800 15200
4.0Go 8.0Go 32Go
40 min 1h20 5h20
7