Memory Card - Spypoint BF-8 Manuel D'utilisation

6
POWER
The battery level is shown on the LCD screen. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
Also note that the voltage of rechargeable AA batteries
(1.2V) is insufficient to power your SPYPOINT
During the installation of the AA batteries, slide the switch
inside the battery case to ALK. Insert the batteries as indicated
inside the battery case. Exact polarity must be followed. We
also recommend the use of new batteries to ensure maximum
performance of your camera.
Lithium battery pack
This camera SPYPOINT
lithium battery pack LIT-09/LIT-C-8 (sold separately, refer to
the OPTIONS section ). This type of battery is less affected by
cold temperatures and lasts up to 3 times longer then an alkaline
battery. During the installation of the lithium battery pack, slide
the switch inside the battery case to LIT-09.
External (12V)
The camera can also be powered from an external 12-volt
DC input such as a 12-volt battery (KIT-12V/BATT-12V, sold
separately) or a 12-volt adapter (AD-12V, sold separately). When
using a 12-volt connection, we recommend removing the AA
batteries to prevent surcharges. During the installation of a 12-
volt connection, slide the switch inside the battery case to ALK.
If combined with a lithium battery pack, slide the switch to
09. For the accessories available, refer to the OPTIONS section.
® camera.
®
can be powered by a rechargeable
Solar panel
This model also offers the possibility of a connection to a
solar panel SP-12V (sold separately, refer to the OPTIONS
section) to maintain the charge of the lithium battery pack
(sold separately, refer to the OPTIONS section) or the 12-volt
battery (sold separately, refer to the OPTIONS section). During
the installation of the rechargeable lithium battery or 12-volt
battery, slide the switch inside the battery case to LIT-09 to
activate the charging system of the solar panel.
Power source
• 6AA
• 12V
• 12V + 6AA
• LIT-09
• 12V + LIT-09
• Solar panel + LIT-09

MEMORY CARD

Using a memory card is required to operate this camera
SPYPOINT
used, the LCD screen displays «CArd» meaning to insert one.
The camera can accept memory cards up to 32 GB capacity.
Before inserting or removing the memory card, the camera must
be turned OFF. Failing to do so may cause loss of or damage the
pictures already recorded from the memory card. When the SD
card is full, the screen indicates FUL. The following data shows
an approximate quantity of photos which can be recorded by
the camera depending on the memory card capacity.
RESOLUTION
3 MP
8 MP
LIT-
VIDEO RESOLUTION
320 x 240
640 x 480
Switch Position
ALK
LIT-09
®
. When the camera is ON and no memory card is
2.0 GB 4.0 GB
2000 4100
1200 2400
2h 4h
65 min 2h10
7
8.0 GB 32 GB
8200 32800
4800 19000
8h 32h
4h10 16h40