Memory Card - Spypoint X-CEL Manuel De L'utilisateur

8

MEMORY CARD

Using a Micro-SD memory card (sold separately, refer to the
section « OPTIONS ») is required to operate the camera
SPYPOINT X-CEL. To insert the card, unscrew the 4 screws
located behind the camera (in the same manner as the batteries).
The Micro-SD card slot is located at the bottom of the camera
(see figure below).
The camera can accept memory cards up to 8 GB. Before
inserting or removing the memory card, the camera must be
turned "OFF". Failing to do so may cause the loss of videos or
damage to the memory card. When the memory card is full, the
LCD panel indicates "FULL". The following chart shows the
approximate time available for recording videos depending on
the memory card capacity.
Note: The use of a class 6 or higher memory card is
recommended. A class 2 or 4 memory card may not support a
data transfer rate high enough to record video from the X-CEL
camera.
Micro-SD card slot
Class 6
SETTINGS
To turn "ON" the camera, press the "ON/OFF" button and hold
for 2 seconds. The same procedure is used to turn "OFF" the
camera.
This video camera is very easy to use. The only setting needed
will be to choose the high resolution "H" or the low resolution
"L". To do this, press once on the "H/L/SOUND" button to
select "H" or press twice to select "L". In "H" setting, the camera
records video in higher quality therefore taking more space
on the memory card. See the previous "MEMORY CARD"
section to know how much time is available on memory card
depending on the setting.
To start recording a video, press the "START/STOP" button. To
stop recording, press the same button again.
Video resolution
H
L
8:88:88
24
H / L / Sound
On / OFF
Number of videos recorded
9
Remaining time
available or duration
of the video
Start / Stop