Memory Card - Spypoint IR-6 Manuel D'utilisation

6
POWER
The battery level is shown on the LCD screen. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
During the installation of AA batteries, place the switch inside
the battery case to "ALK". Insert the batteries as indicated
inside the battery case. Exact polarity must be followed. We
also recommend the use of new batteries to ensure maximum
performance of your camera.
Lithium battery pack
This camera can be powered by a rechargeable lithium battery
LIT-09/LIT-C-8 (sold separately, see OPTIONS). This type of
battery is less affected by cold temperatures and lasts up to 3
times more then an alkaline batteries. During the installation
of lithium battery, place the switch inside the battery case to
"LIT-09".
External (12V)
This camera can be powered from an external 12-volt DC input
such as a 12-volt battery (KIT-12V/BATT-12V, sold separately)
or a 12-volt adapter (AD-12V, sold separately). When using a 12
volt input, we recommend removing the AA batteries to prevent
surcharges. During the installation of a 12-volt connection, place
the switch inside the battery case to "ALK". If combined with
a lithium battery pack, slide the switch to "LIT-09".
the accessories available for the 12-volts, refer to the section
OPTIONS.
All manuals and user guides at all-guides.com
To find
Solar panel
This camera also offers the possibility of a connection to a solar
panel SP-12V (sold separately, see OPTIONS) to maintain
the charge of the lithium battery (sold separately) or the 12-
volt battery (sold separately). During the installation of the
rechargeable lithium battery or 12-volt battery, slide up the
switch inside the battery case up to "LIT-09" to activate the
charging system of the solar panel.

MEMORY CARD

Using a memory card is required to operate this camera. When
the camera is ON and no memory card is used, the LCD panel
displays "CArd" meaning to insert one. The SD slot of the
camera can accept memory cards up to 32 GB capacity. Before
inserting or removing the memory card, the camera must be
turned OFF. Failing to do so may cause damage or loss of the
pictures already recorded on the memory card. When the SD
card is full, the LCD indicates "FULL". The following data
shows an approximate quantity of photos which can be recorded
by the camera depending on the memory card capacity.
RESOLUTION 2.0Go
3 MP 2000
6 MP 1600
VIDEO 2.0Go
RESOLUTION
320 x 240 2h
640 x 480 65 min
"BUSY" LED
The "BUSY" light, located next to the screen, lights up when
the camera is recording.
4.0Go 8.0Go 32Go
4100 8200 32800
3200 6300 25300
4.0Go 8.0Go 32Go
4h 8h 32h
2h10 4h10 16h40
7