Memory Card - Spypoint BLOODLINE Manuel De L'utilisateur

6
Lithium battery pack with charger
The camera SPYPOINT BLOODLINE can be powered by a
rechargeable lithium battery LIT-C-8 (sold separately, refer to
the section «OPTIONS»). This type of battery is less affected
by cold temperatures and lasts up to 3 times more then an
alkaline battery. During the installation of lithium battery, place
the switch inside the battery case to «RECHARGEABLE».
12 volts Power
The camera SPYPOINT BLOODLINE can also be powered
from an external 12 volts DC input. When using a 12 volt
connection, we recommend you to remove the alkaline batteries
to prevent surcharges. To find the accessories available for the
12 volts, refer to the section «OPTIONS».
Solar panel
This model also offers the possibility of a connection to
a solar panel SP-12V (sold separately, refer to the section
«OPTIONS») to maintain the charge of the lithium battery
(sold separately, refer to the section «OPTIONS») or the 12
volt battery (sold separately, refer to the section «OPTIONS»).
During the installation of the rechargeable lithium battery or
12 volt battery, slide up the switch inside the battery case up
to «RECHARGEABLE» to activate the charging system of
the solar panel.

MEMORY CARD

Using a memory card is required to operate the camera
SPYPOINT BLOODLINE. When the camera is « ON » and no
memory card is used, the LCD panel displays « CArd » meaning
to insert one. The SD slot of the camera can accept memory
cards up to 32 GB capacity. Before inserting or removing the
memory card, the camera must be turned « OFF ». Failing to do
so may cause loss of or damage the pictures already recorded
from the memory card. When the SD card is full, the LCD panel
indicates « FULL ». The following data shows an approximate
quantity of photos which can be recorded by the camera
depending on the memory card capacity.