Memory Card - Spypoint IR-10 Manuel De L'utilisateur

26
Lithium battery pack with charger
The camera SPYPOINT IR-10 can be powered by a rechargeable
lithium battery LIT-C-8 (sold separately). This type of battery is
much less affected by cold temperatures and lasts up to 3 times
alkaline batteries. The solar panel SP-12V (sold separately) can
maintain the charge of the lithium battery at any time.
12 volts Power
The camera SPYPOINT IR-10 can also be powered from an
external 12 volts DC input. When using a 12 volt connection,
we recommend removing the alkaline batteries to prevent
surcharges. To find the accessories available for the 12 volts,
refer to the section « OPTIONS ».
electricity
The electrical power is recommended for security purposes. It
provides an instant trigger time when a movement is detected.
We recommend to remove the alkaline batteries when this
power is used. The purchase of a 12 volts DC adapter that can
provide a minimum of 800 mA is required.
Note: when using the electricity power, the Multi-shot mode
and the delay between photos are disabled as the camera starts
instantly every time it detects motion. The temperature mode
is also disabled.

MEMORY CARD

Using a memory card is required to operate the camera
SPYPOINT IR-10. When the camera is « ON » and no memory
card is used, the screen displays « Insert memory card ». The
SD slot of the camera has a 32 GB memory capacity. Before
inserting or removing the memory card, the camera must be
turned « OFF ». Failing to do so may cause loss of or damage
the pictures already recorded from the memory card. When the
SD card is full, the viewing screen indicates « DISK FULL ».
The following data shows an approximate quantity of photos
which can be recorded by the camera depending on the memory
card capacity.