Memory Card - Spypoint IR-5 Manuel De L'utilisateur

24
12 volt Power
The camera SPYPOINT IR-5 can also be powered from an
external 12 volt DC input. When using a 12 volt connection,
we recommend to remove the alkaline batteries to prevent
surcharges. The switch inside the battery case can be placed
to « Rechargeable » or to « Alkaline » without any impact.
To find the accessories available for the 12 volt, refer to the
section « OPTIONS ».

MEMOrY CArD

Using a memory card is required to operate the camera
SPYPOINT IR-5. When the camera is « ON » and no memory
card is used, the LCD panel displays « CArd » meaning to
insert one. The SD slot of the camera can accept memory cards
up to 32 GB capacity. Before inserting or removing the memory
card, the camera must be turned « OFF ». Failing to do so may
cause loss of or damage the pictures already recorded from the
memory card. When the SD card is full, the LCD panel indicates
« FULL ». The following data shows an approximate quantity
of photos which can be recorded by the camera depending on
the memory card capacity.
rESOLUTION 2.0 GB
4 MP 1024
5 MP 816
6 MP 640
8 MP 584
12 MP 480
In « PHOTO » or « VIDEO » mode, if the card is locked, the
panel indicates « LOC » and the light in the front of the camera
winks quickly.
4.0 GB 8.0 GB 32 GB
2048 4096 16384
1632 3264 13056
1280 2560 10240
1168 2336 9344
960
1920 7680
SETTINGS
Date, Time and Picture Quality
Turn « OFF » your camera; set switch « MODE » to « SET/
TEST » and turn « ON » the camera. Press « MENU/OK ». An
« H » will flash on the screen indicating that the camera is in
High Resolution (5 MP). Use the « DOWN » button if you want
to reduce the resolution to « L » (3 MP). Press « MENU/OK »
to set the date and time. Use « UP » and « DOWN » to change
the blinking digit. Once finished, press « MENU/OK » and turn
« OFF » the system to save the changes.
MODE
When the « PHOTO » or « VIDEO » mode is selected, the
test light in the front of the camera flashes for 60 seconds to
allow the user to leave without being photographed or filmed.
When the « SET/TEST » mode is selected, no picture or video
is recorded.
Walk perpendicularly in front of the camera.
the camera detects movement, the light winks to indicate that
normally, a photo or video would be recorded.
not detect the movement, increase the distance detection using the
« DISTANCE »
wheel or realign the system differently. When you
understand how the device responds to detections, you can better
adjust the direction or the height of the installation.
switch is set to « VIEW », you can view the recorded pictures
or videos on television.
DELAY
To select the time interval before the camera records another
photo or video. This option prevents from taking too many
photos or videos.
MULTI-SHOT
To take up to 4 consecutive shots at each detection, with a
10 second delay between each photo. This option allows
up to 4 pictures from different angles when the camera is in
« PHOTO » mode.
VIDEO LENGTH
Allows you to select the recording duration when the camera is
set in « VIDEO » mode.
25
When
If the system does
When the