Publicité
Power cord
Handling the power cord
• The projector should be installed close to an easily accessible power outlet.
• When connecting the power cord to the projector's AC IN terminal, make sure the connector is fully and firmly inserted. Be
sure to fix the power cord using the power cord stopper. Loose connection of the power cord could lead to fire or electric
REQUIRED
shock.
Handling the power cord by following below to avoid fire or electric shock
• When disconnecting the power cord, pull the power cord out by holding onto its plug.
• Unplug the power cord from the power outlet before cleaning the product or when not planning to use the product for an
extended time.
REQUIRED
• When the power cord or plug is heat or damaged, unplug the power cord from the power outlet, and contact your dealer.
UNPLUG THE
POWER CORD
Periodically clean dust and other debris from the power plug
• Failure to do so could result in fire or electric shock.
REQUIRED
Disconnect power cords and other cables before moving the projector
• Before moving the product, make sure the product power is off, then unplug the power cord from the power outlet and
check that all cables connecting the product to other devices are disconnected.
REQUIRED
Do not use the power cord with a power tap
• Adding an extension cord may lead to fire as a result of overheating.
PROHIBITED
Installation
Securing the lens unit with the fall prevention wire
• If the projector is going to be suspended from a ceiling or another high place, secure the lens unit using the fall prevention
wire (sold separately). If the lens unit is not secured, it may fall down if it comes lose.
REQUIRED
On use
Do not use on networks subject to overvoltage.
• Connect the projector's HDBaseT port and LAN port to a network for which there is no risk of overvoltage being applied.
Overvoltage applied to the HDBaseT or LAN port could result in electric shock.
PROHIBITED
Lens shift, focus and zoom operations
• When shifting the lens or adjusting the focus or zoom, do so from either behind or the side of the projector. If adjustments
are performed from the front, your eyes could be exposed to strong light and get injured.
• Keep your hands away from the lens area when performing the lens shift operation. If not, your fingers could get caught in
REQUIRED
the gap between the cabinet and the lens.
CAUTION
EN-7
Publicité
