Publicité
Power supply
Use a suitable voltage power supply.
• This projector is designed to be used with a 100–240 VAC, 50/60 Hz power supply. Before using the projector, check that
the power supply to which the projector is to be connected meets these requirements.
• Use a power outlet as the projector's power supply. Do not connect the projector directly to electrical light wiring. Doing
REQUIRED
so is dangerous.
Connecting the power cord to earth
• This equipment is designed to be used in the condition of the power cord connected to earth. If the power cord is not con-
nected to the earth, it may cause electric shock. Please make sure the power cord is connected to the wall outlet directly
and earthed properly.
MUST BE
Do not use a 2-pin plug converter adapter.
EARTHED
• Be sure to connect the projector and the computer (signal source) to the same earth point. If the projector and the computer
(signal source) will be connected to different earth points, fluctuations in the earth potential may cause fire or smoke.
Handling the power cord
• Please use the power cord supplied with this projector. If the supplied power cord does not satisfy requirements of your
country's safety standard, and voltage and current for your region, make sure to use the power cord that conforms to and
satisfies them.
REQUIRED
• The power cord included with this projector is exclusively for use with this projector. For safety, do not use it with other
devices.
PROHIBITED
• Handle the power cord with care. Damaging the cord could lead to fire or electric shock.
- Do not place heavy objects on the cord.
- Do not place the cord under the projector.
HAZARDOUS
- Do not cover the cord with a rug, etc.
VOLTAGE
- Do not scratch or modify the cord.
- Do not bend, twist or pull the cord with excessive force.
- Do not apply heat to the cord.
Should the cord be damaged (exposed core wires, broken wires, etc.), ask your dealer to replace it.
• Do not touch the power plug should you hear thunder. Doing so could result in electric shock.
• Do not connect or disconnect the power cord with wet hands. Doing so could result in electric shock.
DO NOT TOUCH
WITH WET
HANDS
Installation
Do not use in places such as those described below.
• Do not use in places such as those described below. Doing so could lead to fire or electric shock.
- Shaky tables, inclined surfaces or other unstable places.
- Poorly ventilated spaces.
PROHIBITED
- Near a radiator, other heat sources, or in direct sunshine.
- Continual vibration areas.
- Humid, dusty, steamy, or oily areas.
- An environment where there are corrosive gases (sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia,
ozone, etc.).
- Outdoors.
- High-temperature environment where humidity changes rapidly and condensation is likely to occur.
• Do not use in places such as those described below where the projector could get wet. Doing so could lead to fire or electric
shock.
- Do not use in the rain or snow, on a seashore or waterfront, etc.
DO NOT WET
- Do not use in a bathroom or shower room.
- Do not install under equipment that discharges water, such as air conditioners.
- Do not place vases or potted plants on the projector.
- Do not place cups, cosmetics or medicines on the projector.
UNPLUG THE
Should water, etc. get inside the projector, first turn off the projector's power, then unplug the power cord from the power
POWER CORD
outlet and contact your dealer.
WARNING
• The power cord you use must be approved by and comply with the safety standards of your country.
Please refer to the "Specifications" in the user's manual about the power cord specification.
For selecting an appropriate power cord, please check rated voltage for your region by yourself.
EN-5
Publicité
