Save The Values; Troubleshooting; General Errors - StarLab Mixer HC Manuel D'utilisation

To end the program before the run is complete:
1. Press the "START/STOP" key again.
2. To return to the mode of basic temperature control, press the „PROGR." key.
In the „Temp control" mode the
5.5.8

Save the values

The set values will be saved even after the unit has been switched off.
6

TROUBLESHOOTING

6.1 General errors

If the proposed measures to remedy the fault repeatedly do not deliver the desired
result, contact your local distributor.
Symptom / message
Display remains dark.
Nominal temperature
is not reached.
The unit does not mix
or control the tempe-
rature.
signs will appear for the individual programming steps.
Cause
No mains connection.
Defective fuse.
At nominal values over
4 °C above room temper-
ature.
Various causes are possible.
Remedy
Check the mains connection and
i
the power supply.
Switch the device on.
i
Change the fuse.
i
Set up the device in a cooler
i
environment.
Contact your local distributor.
i
Mixer HC · User Manual ·
23