Inserting Exchangeable Thermoblocks - StarLab Mixer HC Manuel D'utilisation

5.2 Inserting exchangeable thermoblocks

Warning! Risk of injury through chemical or mechanical damage to exchangeable
thermoblocks.
Check the exchangeable thermoblocks regularly.
i
Do not use exchangeable thermoblocks that show signs of corrosion or mechanical
i
damage.
Warning! Injury or property damage from improperly attached exchangeable
thermoblocks.
If the exchangeable thermoblocks are not attached properly, they can become detached
from the device or break.
Tighten the screws of the exchangeable thermoblocks so they are hand-tight.
i
Warning! Contamination due to opening tube lids.
In the following cases, the lids of tubes can spring open and the sample material can
escape:
high vapor pressure of the content,
i
improperly sealed lid,
i
damaged sealing lip.
i
Always check that all tubes have been sealed tightly before use.
i
The following exchangeable thermoblocks can be set on the Mixer HC:
Thermoblock for
Thermoblock for
Thermoblock for
Thermoblock for
Thermoblock for
Thermoblock for
Thermoblock for
Thermoblock for
Thermoblock for
Adapter plate
To insert the exchangeable thermoblocks, use the accessories supplied (eg. screw driver,
screws, flat washers and lock washers).
16
· Mixer HC · User Manual
24 x 0.5 ml microcentrifuge tubes
24 x 1.5 ml microcentrifuge tubes
24 x 2.0 ml microcentrifuge tubes
24 x micro tubes, diameter 12 mm
8 x 5.0 ml preparation tubes
8 x 15 ml conical centrifuge tubes
4 x 50 ml conical centrifuge tubes
24 x 1.5/2.0 ml cryogenic tubes
MTP / DWP with lid
96 x 0.2 ml for PCR plates and tubes for MTP / DWP thermoblock