Publicité
Setting permanent display of the
weight value (HOLd)
Setting filtering (FIL)
Setting the standby time (AOFF)
3. Select the desired setting:
–
On
–
OFF
4. Confirm your selection.
ð The setting is adopted.
ð The menu closes.
If the
function is activated, or you have pressed the
Autohold
weight value is displayed permanently. You can select when the weight value
display is automatically cleared again.
1. From the menu, select the
2. Confirm your selection.
ð The current setting is displayed.
3. Select the desired setting:
–
HOLD1
: A new load on the measuring station clears the display value
–
: Removing the load from the measuring station clears the dis-
HOLD2
play value
4. Confirm your selection.
ð The setting is adopted.
ð The menu closes.
Filtering reduces interference (due to patient movement, for example) when
measuring weight. You can modify the strength of filtering.
1. From the menu, select the
2. Confirm your selection.
ð The current setting is displayed.
3. Select a filtering level:
–
0
: low filtering
–
: moderate filtering
1
–
2
: high filtering
4. Confirm your selection.
ð The setting is adopted.
ð The menu closes.
In battery mode the device remains on standby for 30 seconds (factory setting).
If there is no input or no load is put on the weighing platform during the standby
time, the device switches off automatically. Measuring results will be discarded.
You can adjust standby time as follows:
Function
Factory setting
Increment
Minimum standby time
Maximum standby time
1. From the menu, select the
2. Confirm your selection.
ð The time currently set is displayed (in this case: 30 seconds).
3. Select the desired time:
– To increase value:
– To reduce value:
4. Confirm your selection.
ð The setting is adopted.
ð The menu closes.
menu item.
HOLd
menu item.
FIL
Setting
30 seconds
30 seconds
30 seconds
600 seconds (10 minutes)
AOFF
menu item.
key
Hold
BMI
key
English
key, the
Hold
Operation • 39
Publicité
