Publicité
26 • seca 787/797
3. Remove the display unit:
f) Undo the cross-head screw behind the display unit
g) Remove both cable tie on cable hook and the strain relief, if present
h) Draw cables out of the cable hook
i) Lift off the display unit
4. Switch the positions of the display unit and the battery holder:
j) Put the battery holder in its new position
k) Carefully put the display unit in its new position
5. Route the cables so that they do not dangle out of the display head.
NOTE
– When fitting on the right-hand operating side: You can gather all the
cables into the cable hook and secure them with a cable tie if neces-
sary.
–
only: If a barcode scanner is installed, route the barcode
seca 797
scanner cable over the strain relief and secure with a cable tie if re-
quired
(ž Connecting the barcode scanner (seca
6. Mount the display unit:
l) Hold the display unit steady
m) Tighten the cross-head screw behind the display unit
7. Fit the battery compartment lid:
n) Insert the battery compartment lid and hold it steady
o) Tighten the cross-head screw behind the battery compartment lid
797), page 31).
Publicité
