Publicité
Entering height
Measuring heights > 1.22 m
36 • seca 787/797
6. Read off the measuring result below the head slide (read-off edge 1).
ð You have the following options for continuing:
► Make a note of the measuring result.
► Enter the measuring result on the display unit
height, page 36).
7. Ask the patient to step off the weighing platform.
8. Fold down the measuring flap.
9. Push up the head slide until it engages in the lock.
If you are measuring in the range < 1.22 m, the height must be entered on the
display unit in order to use the following functions:
• Calculating BMI
(ž Calculating and displaying body mass index
(BMI), page 37)
• Transmitting measured values to the
(ž Scanning ID(s) and transmitting data via WiFi (seca
1. Determine the height
(ž Measure
2. Press the
key.
Height
ð The message
SEt
and the last height entered are displayed.
3. Use the
and
Hold
4. Press the
key.
ð The height is permanently displayed.
NOTE
During height measurement, the value in the display changes as fol-
lows:
– The value in the display changes as long as you are moving the up-
per telescopic element.
– The value flashes as soon as you stop moving the telescopic ele-
ment.
– After approx. 20 s, the value stops flashing and
Press the
Height
1. Fold up the measuring flap until it engages in a horizontal position.
2. Extend the upper telescopic element until the patient can get under the mea-
suring flap comfortably.
3. Ask the patient to stand under the measuring flap and to stand up straight.
(ž Entering
seca connect 103
height, page 35).
key to enter the height.
BMI
key to permanently display the value.
software via WIFI
797), page 38)
is displayed.
- - - - -
Publicité
