Publicité
Switching the positions of the
display unit and the battery
compartment
Left-hand
operating side
Right-hand
operating side
8. Connect the connector cable:
a) Pull the connector cable out of the column
b) Route the connector cable past the cable clip and plug into the socket of
the weighing platform
c) Fix the connector cable in position using the cable clip
9.
only: Connect the display cable:
seca 797
d) Draw the display cable out of the column
e) Plug the display cable into the labeled socket (
f) Fix the display cable in position with the cable clip
10. Set the measuring station in an upright position.
11. Remove the protective film from the display (if desired).
At the factory, the display unit is fitted to the right-hand operating side of the dis-
play head. The battery compartment is on the left-hand operating side.
Proceed as follows to switch the positions of the display unit and the battery
compartment:
1. Remove the cover panel:
a) Unscrew two cross-head screws
b) Remove the cover panel
2. Remove the battery compartment lid:
c) Hold the battery compartment lid steady
d) Remove the cross-head screw behind the battery compartment lid
e) Remove the battery compartment lid
English
)
display cable
Starting up device • 25
Publicité
